Silver‐Assisted Chemical Etching on Silicon with Polyvinylpyrrolidone‐Mediated Formation of Silver Dendrites

Metal‐assisted chemical etching (MaCE) on silicon (Si)—mediated by polyvinylpyrrolidone (PVP)—is systematically investigated herein. It is found that the morphologies and crystallographic natures of the grown silver (Ag) dendrites can be significantly modulated, with the presence of PVP in the MaCE process leading to the formation of faceted Ag dendrites preferentially along the (111) crystallographic phase, rather than along the (200) phase. Further explorations of the PVP‐mediated effect on Si etching are also revealed. In contrast to the aligned Si nanowires formed by MaCE without PVP addition, only distributed nanopores with sizes of 200 to 400 nm appear on the Si surfaces in the presence of PVP. The origin of surface polishing on Si in the PVP‐mediated MaCE process can be attributed to the distinct transport pathway of holes supplied by the Ag⁺ ions, where the holes are injected directly into the primary Ag seeds, rather than through Ag dendrites, thus leading to the isotropic etching of the Si surface.     

Ionic‐liquid‐based,manual‐shaking‐ and ultrasound‐assisted,surfactant‐enhanced emulsification microextraction for the determination of three fungicide residues in juice samples

A novel manual‐shaking‐ and ultrasound‐assisted surfactant‐enhanced emulsification microextraction method was developed for the determination of three fungicides in juice samples. In this method, the ionic liquid, 1‐ethyl‐3‐methylimidazolium bis[(trifluoromethyl)sulfonyl]imide, instead of a volatile organic solvent was used as the extraction solvent. The surfactant, NP‐10, was used as an emulsifier to enhance the dispersion of the water‐immiscible ionic liquid into an aqueous phase, which accelerated the mass transfer of the analytes. Organic dispersive solvent typically required in common dispersive liquid–liquid microextraction methods was not necessary. In addition, manual shaking for 15 s before ultrasound to preliminarily mix the extraction solvent and the aqueous sample could greatly shorten the time for dispersing the ionic liquid into aqueous solution by ultrasound irradiation. Several experimental parameters affecting the extraction efficiency, including type and volume of extraction solvent, type and concentration of surfactant, extraction time, and pH, were optimized. Under the optimized conditions, good linearity with the correlation coefficients (γ) higher than 0.9986 and high sensitivity with the limit of detection ranging from 0.4 to 1.6 μg/L were obtained. The average recoveries ranged from 61.4 to 86.0% for spiked juice, with relative standard deviations from 1.8 to 9.7%. The proposed method was demonstrated to be a simple, fast, and efficient method for the analysis of the target fungicides in juice samples.     

Optimization of microwave‐assisted extraction for six inorganic and organic arsenic species in chicken tissues using response surface methodology

Response surface methodology was applied to optimize the parameters for microwave‐assisted extraction of six major inorganic and organic arsenic species (As(III), As(V), dimethyl arsenic acid, monomethyl arsenic acid, p‐arsanilic acid, and roxarsone) from chicken tissues, followed by detection using a high‐performance liquid chromatography with inductively coupled mass spectrometry detection method, which allows the simultaneous analysis of both inorganic and organic arsenic species in the extract in a single run. Effects of extraction medium, solution pH, liquid‐to‐solid ratio, and the temperature and time of microwave‐assisted extraction on the extraction of the targeted arsenic species were studied. The optimum microwave‐assisted extraction conditions were: 100 mg of chicken tissue, extracted by 5 mL of 22% v/v methanol, 90 mmol/L (NH₄)₂HPO₄, and 0.07% v/v trifluoroacetic acid (with pH adjusted to 10.0 by ammonium hydroxide solution), ramping for 10 min to 71°C, and holding for 11 min. The method has good extraction performance for total arsenic in the spiked and nonspiked chicken tissues (104.0 ± 13.8% and 91.6 ± 7.8%, respectively), except for the ones with arsenic contents close to the quantitation limits. Limits of quantitation (S/N = 10) for As(III), As(V), dimethyl arsenic acid, monomethyl arsenic acid, p‐arsanilic acid, and roxarsone in chicken tissues using this method were 0.012, 0.058, 0.039, 0.061, 0.102, and 0.240 mg/kg (dry weight), respectively.     

Ultrasound‐assisted emulsification microextraction coupled with high‐performance liquid chromatography for the simultaneous determination of fragrance allergens in cosmetics and water

A simple, inexpensive, and environmentally friendly method based on ultrasound‐assisted emulsification microextraction followed by solidification of floating organic drop and high‐performance liquid chromatography coupled to diode array detection was developed for the simultaneous determination of 18 potentially allergenic fragrance substances. Several parameters affecting the microextraction process were investigated in detail by the “one‐variable‐at‐a‐time” approach. Optimal conditions were the following: 50 μL of 2‐dodecanol as extraction solvent, 10 mL of sample containing 150 g/L of salt, and 5 min of sonication at 35°C. Under the optimized conditions, method showed good linearity in the selected ranges, with squared correlation coefficients ranging from 0.948 to 0.999. Limits of detection ranged from 0.001 to 0.154 μg/mL and enrichment factors from 9 to 237. Precision of the method, expressed as relative standard deviation, was checked at two levels obtaining good results (3.3–14.4%). Recovery studies were made in baby bath water and in eau de cologne showing acceptable accuracy. Finally, the developed method was successfully applied to different commercial cosmetic and water samples. The most commonly found analyte was linalool followed by cinnamal and lilial. Most of the analyzed samples contained at least one of the target compounds.     

Vortex‐assisted liquid–liquid microextraction using a low‐toxicity solvent for the determination of five organophosphorus pesticides in water samples by high‐performance liquid chromatography

Vortex‐assisted liquid–liquid microextraction followed by high‐performance liquid chromatography with UV detection was applied to determine Isocarbophos, Parathion‐methyl, Triazophos, Phoxim and Chlorpyrifos‐methyl in water samples. 1‐Bromobutane was used as the extraction solvent, which has a higher density than water and low toxicity. Centrifugation and disperser solvent were not required in this microextraction procedure. The optimum extraction conditions for 15 mL water sample were: pH of the sample solution, 5; volume of the extraction solvent, 80 μL; vortex time, 2 min; salt addition, 0.5 g. Under the optimum conditions, enrichment factors ranging from 196 to 237 and limits of detection below 0.38 μg/L were obtained for the determination of target pesticides in water. Good linearities (r > 0.9992) were obtained within the range of 1–500 μg/L for all the compounds. The relative standard deviations were in the range of 1.62–2.86% and the recoveries of spiked samples ranged from 89.80 to 104.20%. The whole proposed methodology is simple, rapid, sensitive and environmentally friendly for determining traces of organophosphorus pesticides in the water samples.     

Dialkyl phosphates determination by gas chromatography: Evaluation of a microwave‐assisted derivatization†

Dialkyl phosphates are organophosphate insecticide metabolites and their urinary analysis is useful for assessing human exposure to these compounds. This study presents a sample preparation method with microwave‐assisted derivatization for two dialkyl phosphates to make the process faster before gas chromatographic analysis. The optimized conditions for derivatization procedure were: 250 μL of 2,3,4,5,6‐pentafluorobenzyl bromide 3% in acetonitrile for derivative; microwave for 5 min with intensity of 160 W. The electron ionization mass spectrometric analysis was performed using a gas chromatography with mass spectrometry QP‐2010 from the Shimadzu^® equipped with RTx^®‐5MS capillary column. Ions were monitored at selected‐ion monitoring mode at m/z 350 for diethyl thiophosphate and m/z 366 for diethyl dithiophosphate. The developed method was linear for both metabolites. The intra‐assay precision was the values ranged between 1.1 and 9.1%, for diethyl thiophosphate, and between 4.06 and 6.9%, for diethyl dithiophosphate. The interassay precision showed relative standard deviation between 10.3 and 15.1%, for diethyl thiophosphate and between 4.9 and 11.9%, for diethyl dithiophosphate. The results obtained suggests that derivatization assisted by microwave, before gas chromatography with mass spectrometry analysis, can be applied to monitoring of exposure to organophosphates once is fast, sensible, and precise method to determinate dialkyl phosphates.     

Dicyclohexylammonium bromoacetate: a low molecular mass organogelator with a one‐dimensional secondary ammonium monocarboxylate (SAM) synthon

The asymmetric unit of the title salt, C₁₂H₂₄N⁺·C₂H₂BrO₂⁻, contains a dicyclohexylammonium cation connected to a bromoacetate anion by means of an N—H...O hydrogen bond. In the crystal, the ion pairs assemble via N—H...O interactions, forming zigzag infinite chains parallel to the c axis with the (...H—N—H...O—C—O...)_n motif that is considered to be a prerequisite for ensuring gelation properties of secondary ammonium monocarboxylate salts. The title salt was characterized by FT–IR, X‐ray powder diffraction (XRPD), TG–DTA and ¹H NMR spectroscopy in solution. Gelation experiments revealed that dicyclohexylammonium bromoacetate forms molecular gels with dimethylformamide and dimethyl sulfoxide. Scanning electron microscopy (SEM) was used to reveal morphological features of dried gels.     

微波消解-ICP-MS法测定药用明胶空心胶囊中微量重金属元素

采用微波消解技术,建立了一种电感耦合等离子体质谱法测定明胶空心胶囊中Cr,Co,Ni,Cu,Zn,As,Cd,Hg和Pb 9种微量重金属元素的方法。确定了微波消解仪和等离子体质谱仪的最佳操作参数,研究共存离子的干扰和消除方法,选择了各元素的测定同位素,以Ge,Rh和Tl为内标补偿基体效应,建立了样品测定方法。应用拟定的方法测定了不同生产厂家、不同批次的空心胶囊中微量重金属的含量。方法对试样中各元素测定的相对标准偏差为1.5%~14.1%,加标回收率在90.0%~102.0%。结果表明,方法简便、快速、灵敏,满足于空心胶囊中9种重金属元素的测定要求。     

Two novel organic–inorganic hybrid materials from tetrachloridometallate(II) salts and 4‐[(E)‐2‐(pyridin‐1‐ium‐2‐yl)ethenyl]pyridinium

Two organic–inorganic hybrid compounds have been prepared by the combination of the 4‐[(E)‐2‐(pyridin‐1‐ium‐2‐yl)ethenyl]pyridinium cation with perhalometallate anions to give 4‐[(E)‐2‐(pyridin‐1‐ium‐2‐yl)ethenyl]pyridinium tetrachloridocobaltate(II), (C₁₂H₁₂N₂)[CoCl₄], (I), and 4‐[(E)‐2‐(pyridin‐1‐ium‐2‐yl)ethenyl]pyridinium tetrachloridozincate(II), (C₁₂H₁₂N₂)[ZnCl₄], (II). The compounds have been structurally characterized by single‐crystal X‐ray diffraction analysis, showing the formation of a three‐dimensional network through X—H...Cl_nM⁻ (X = C, N⁺; n = 1, 2; M = Co^II, Zn^II) hydrogen‐bonding interactions and π–π stacking interactions. The title compounds were also characterized by FT–IR spectroscopy and thermogravimetric analysis (TGA).     

微波消解-磷钼蓝分光光度法测定钨矿石中的磷含量

针对钨矿石中的微量元素磷,采用混合酸快速微波消解结合磷钼蓝分光光度法进行测定。经选择优化样品的微波消解和实验测定条件,结果表明:HCl+HNO3+HF的混合酸微波消解后的样品,在硫酸介质中,有钼酸铵存在时,用抗坏血酸将磷还原成磷钼蓝络合物,在825nm处比色测定。方法的加标回收率为98.9%~101.6%,结果准确可靠。硅在熔样过程中挥发除去不会干扰测定,砷会干扰实验,可在酸介质中加入碘化钾,使砷还原至低价而不干扰磷的测定。